1. The size and assembly of plastic spray products should meet the requirements of cargo lift drawings, and meet the corresponding technical requirements and national standards.
2. After the sprayed product is sent for inspection, try to install a corresponding semi-finished goods lift to verify that the structure of the product is correct, and the sprayed product is required to be easy to install. The semi-finished product for trial installation requires that the installation hole position does not shift, and the screw installation can be fastened in place without skewing: the position, height, and clearance of the device outside the sprayed product must be appropriate; no deviation is allowed to be on the edge of the product hole or even exposed The upper and lower covers of the plastic-sprayed product are closely matched, and the installation and disassembly are convenient; the riveting sleeve in the plastic-sprayed product is not allowed to loosen or even fall off.
3. Visual inspection is used for appearance, and normal or corrected vision is used to check whether the surface of the freight lifter is normal.
4. The sprayed color should be consistent with the selected sample or color plate, the surface of the Electric stacker lifter after spraying is uniform in color, and there is no obvious color difference by visual inspection.
5. The thickness of the spray coating should meet the design and use requirements, with uniform spray thickness and strong adhesion.
6. The visible surface parts inside and outside the reach stacker should be clean, free of any dirt, oil stains, etc. that affect the appearance, and no white marks left after the finger is scratched.
7. Check that the content and color of the silk screen of the sprayed plastic products meet the requirements of the design drawings, and the silk screen is clear, and it is not allowed to have large silk screen broken lines caused by wrong printing, missing printing, color inconsistency, unrecognizable or defective.
8. The surface of the electric pallet stacker is not allowed to be bumped or deformed, and the surface should be smooth and free of corners and corners.
9. The surface of the Electric lift stacker is not allowed to be scratched due to friction.
10. The surface of the stacker and freight elevator should not have flakes of small plastic powder particles, silk screen ink dots, bumps, protruding marks or flow plastic marks, and dispersion and a small amount of particles are allowed.
11. The surface of the electric forklift and the industrial goods lift should not have pits in pieces, and they are allowed to exist in small amounts.
12. There should be no scratches on the surface of the electric reach forklift and warehouse goods lift, let alone deep scratches, and no leakage of the bottom plate; there should be no scratches on the surface of the sprayed product, only scattered and small amounts are allowed.
